User manual JRC NSVS776
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JRC NSVS776. We hope that this JRC NSVS776 user guide will be useful to you.
Manual abstract: user guide JRC NSVS776
Detailed instructions for use are in the User's Guide.
[. . . ] 2005
JRC SAW FILTER
NSVS776
Application
374MHz WLAN
Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig. 1. Input and Output Impedance 50 Nominal Center Frequency (f0) 374MHz Insertion Loss 365. 5~382. 5MHz 12. 0dB max. [. . . ] 1 2 3 4 5 6 7 8 Connection GND IN IN GND GND OUT OUT GND
1 . 5 ±0 . 2
2 1 8
(1. 27)
6 7
Fig. 2 Package dimensions (in mm)
6. 0 1. 0 1. 6 [6x]
1. 0 [6x]
5. 3 1. 27
1. 27
Via -Hole( 0. 3) [3x]
Fig. 3 Desirable land area (in mm)
NSVS776 Jan. It might not be satisfied with electrical specification without operating temperature range. When it is used less than -30ºC or more than +80ºC, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350ºC max. , the time of soldering: 10 seconds max. , the power of soldering iron: 30W max. . Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. Confirm that there are not any influence for qualification to this component in mounting on PCB when this component is cleaned. As it might be a cause of degradation of destruction to apply static electricity to this component, do not apply static electricity or excessive voltage while assembling and measuring. This specification specifies the quality of this component as a single unit. [. . . ] When intending to use any our product please contact our sales representatives in advance.
NSVS776 Jan. 2005
FREQUENCY CHARACTERISTICS
0 Insertion Loss [dB] 10 20 30 40 50 60 340 360 380 40 420 Frequency [MHz] 8 12 16 20 24
1000 Group Delay [ns] 800 600 400 200 0 340 360 380 400 Frequency [MHz] 420
S11
S22 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE JRC NSVS776
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JRC NSVS776 will begin.