User manual JRC NSVS1147
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JRC NSVS1147. We hope that this JRC NSVS1147 user guide will be useful to you.
Manual abstract: user guide JRC NSVS1147
Detailed instructions for use are in the User's Guide.
[. . . ] 2005
JRC SAW FILTER
NSVS1147
Application
426. 5MHz Low Power Transceiver
Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig. 1. Electrical Specifications Item Nominal Center Frequency (f0) 3dB Band Width Insertion Loss f0±150kHz Ripple f0±150kHz 429·` 430MHz Attenuation 850·` 860MHz 1280·` 1290MHz
Spec. [. . . ] 1 2 3 4 5 6 7 8
1 . 0·} 0. 2
X Y Z 0 1 2
1 8
7
Fig. 2 Package Dimensions (in mm)
4. 3 1. 3 [6x] 0. 8 [6x]
Connection GND IN/OUT GND GND GND OUT/IN GND GND
1. 27
1. 27
Via - Hole( Ó
0. 3)
0. 8
Fig. 3 Desirable land area (in mm)
4. 3
NSVS1147 Jan. It might not be satisfied with electrical specification without operating temperature range. When it is used less than 10ºC or more than +50ºC, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350ºC max. , the time of soldering: 10 seconds max. , the power of soldering iron: 30W max. . Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. Confirm that there are not any influence for qualification to this component in mounting on PCB when this component is cleaned. As it might be a cause of degradation of destruction to apply static electricity to this component, do not apply static electricity or excessive voltage while assembling and measuring. This specification specifies the quality of this component as a single unit. [. . . ] When intending to use any our product please contact our sales representatives in advance.
NSVS1147 Jan. 2005
LQW18AN68NG00D 68nH
1
8
7
LQW18AN68NG00D 68nH
IN 50
GRM1554C1H0R50CZ01J 0. 5pF
2 SA W 6 3 4 5 OUT 50
GRM1554C1H0R50CZ01J 0. 5pF
Fig. 4 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE JRC NSVS1147
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JRC NSVS1147 will begin.