User manual JRC NSVS1123

[. . . ] 2005 JRC SAW FILTER Application NSVS1123 243. 95MHz PHS 1st IF Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig. 1. Table 1. [. . . ] 2005 110nH IN50 2. 0pF 1 6 2 SAW 5 3 4 110nH 2. 0pF OUT 50 Fig. 1 Measuring Circuit (a) 3. 00±0. 15 (b) (c) 3. 00±0. 15 (2) (3. 0) (0. 25) (0. 6) (1) (R0. 30) [4x] Marking (1) Lot Number (a) Year (b) Month *Oct. --Nov. --Dec. --(c) Date 1 - 9 --10 -19 --20 -31 --(2) Part Number Mark 1. 15±0. 15 (0. 3) (R0. 15) [4x] X Y Z 0 1 2 (1. 27) (0. 6) (1. 8) (1. 27) (R0. 15) [4x] [2x] (0. 45) (0. 75) [6x] Fig. 2 Package Dimensions (in mm) 3. 8 0. 93 2. 2 3. 8 0. 6 1. 15 1. 15 0. 93 Fig. 3 Desirable land area (in mm) [4x] Pin no. 1 2 3 4 5 6 Connection GND IN GND GND OUT GND (0. 53) NSVS1123 Jul. It might not be satisfied with electrical specification without operating temperature range. When it is used less than ­10ºC or more than +60ºC, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350ºC max. , the time of soldering: 10 seconds max. , the power of soldering iron: 30W max. . Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. [. . . ] It is therefore advisable to contact Japan Radio Company before proceeding with the design of equipment incorporating this product. [. . . ]