User manual JRC NSVS1115

[. . . ] 2005 JRC SAW FILTER NSVS1115 Application 380MHz WCDMA Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig. 1. Electrical Specifications Parameter Input and Output Impedance Nominal Center Frequency (f0) Pass Bandwidth Insertion Loss 378. 08~381. 92MHz Response Variation 378. 08~381. 92MHz Group Delay Variation 378. 08~381. 92MHz Out of Band Rejection 350. 0~370. 0MHz 370. 0~375. 0MHz 385. 0~410. 0MHz Spec. [. . . ] Connection 1 2 GND(PKG) GND(PKG) GND(PKG) GND(PKG) OUT GND(signal) GND(PKG) GND(PKG) GND(PKG) GND(PKG) IN GND(signal) (0. 8) [12 ×] 3 4 5 6 7 8 12 (2. 54±0. 15) 1 2 3 4 5 11 10 9 8 7 6 9 10 11 12 (R0. 3) [12×] Fig. 2 Package dimensions (in mm) NSVS1115 Jan. It might not be satisfied with electrical specification without operating temperature range. When it is used less than -10ºC or more than +75ºC, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350ºC max. , the time of soldering: 10 seconds max. , the power of soldering iron: 30W max. . Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. Confirm that there are not any influence for qualification to this component in mounting on PCB when this component is cleaned. As it might be a cause of degradation of destruction to apply static electricity to this component, do not apply static electricity or excessive voltage while assembling and measuring. This specification specifies the quality of this component as a single unit. [. . . ] When intending to use any our product please contact our sales representatives in advance. 3. NSVS1115 Jan. 2005 FREQUENCY CHARACTERISTICS 10 20 Insertion Loss [dB] 14 15 16 17 18 19 20 21 360 380 400 22 420 30 40 50 60 70 80 90 340 Frequency [MHz] 2000 G roup Delay [ns] 1800 1600 1400 1200 1000 376 378 380 382 384 Frequency [MHz] S11 S22 [. . . ]