User manual JRC NSVS1097

[. . . ] 2005 JRC SAW FILTER NSVS1097 Application 243. 95MHz PHS Base-Station 1st IF Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig. 1. Table 1. Electrical Specifications Item Nominal Center Frequency (f0) 3dB Band Width Insertion Loss at f0 Ripple f0±100kHz Group Delay Time Ripple f0±100kHz Attenuation f0±600kHz f0±10. 7MHz f0±21. 4MHz Spec. [. . . ] 1 2 3 4 5 6 7 8 X Y Z 0 1 2 1 8 7 Fig. 2 Package Dimensions (in mm) 4. 3 1. 3 [6x] 0. 8 [6x] Connection GND IN/OUT GND GND GND OUT/IN GND GND 1. 27 1. 27 Via - Hole( Ó 0. 3) 0. 8 Fig. 3 Desirable land area (in mm) 4. 3 NSVS1097 Jan. It might not be satisfied with electrical specification without operating temperature range. When it is used less than ­30ºC or more than +85ºC, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350ºC max. , the time of soldering: 10 seconds max. , the power of soldering iron: 30W max. . Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. Confirm that there are not any influence for qualification to this component in mounting on PCB when this component is cleaned. As it might be a cause of degradation of destruction to apply static electricity to this component, do not apply static electricity or excessive voltage while assembling and measuring. This specification specifies the quality of this component as a single unit. [. . . ] When intending to use any our product please contact our sales representatives in advance. NSVS1097 Jan. 2005 TZY2Z2R5A001B00 0. 65 - 2. 5 pF LQW18ANR10G00D 100nH 1 8 7 6 5 TZY2Z2R5A001B00 0. 65 - 2. 5 pF LQW18ANR10G00D 100nH 2 SA W IN 50 3 4 OUT 50 TZY2Z2R5A001B00 0. 65 - 2. 5 pF TZY2Z2R5A001B00 0. 65 - 2. 5 pF Fig. [. . . ]