User manual JRC NSVA372
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JRC NSVA372. We hope that this JRC NSVA372 user guide will be useful to you.
Manual abstract: user guide JRC NSVA372
Detailed instructions for use are in the User's Guide.
[. . . ] 2005
JRC SAW FILTER
NSVA372
Application
325MHz PAGER
Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig. 1. Input and Output Impedance 230//-5pF Nominal Center Frequency (f0) 325MHz Insertion Loss 321~329MHz 5. 5dB max. [. . . ] It might not be satisfied with electrical specification without operating temperature range. When it is used less than -10ºC or more than +60ºC, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350ºC max. , the time of soldering: 10 seconds max. , the power of soldering iron: 30W max. . Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. Confirm that there are not any influence for qualification to this component in mounting on PCB when this component is cleaned. As it might be a cause of degradation of destruction to apply static electricity to this component, do not apply static electricity or excessive voltage while assembling and measuring. This specification specifies the quality of this component as a single unit. Make sure that this component is evaluated and confirmed against this specification when it is mounted to your products. [. . . ] 325 [MHz] Freq. Span 100 [MHz]
J4Y1 VS971
6. 5±0. 20
Insertion Loss
(R0. 3) [4×] (3)
Marking (1) Manufacture's Mark (2) Lot Number (a) Year
0 Reference 0 [dB] Division 10 [dB] 40 20
2. 0 max.
(b) Month *Oct. --- X Nov. --- Y Dec. --- Z (c) Date
(0. 76)
(2. 54)
(2. 54)
1 --- 0 -9 10 -19 --- 1 20 -31 --- 2 (3) Part Number Mark
60
(2. 54±0. 15)
(1. 4)
[12×]
Pin No. Connection 1 2 GND(PKG) GND(PKG) GND(PKG) GND(PKG) OUT/IN GND(signal) GND(PKG) GND(PKG)
(0. 8)
80
12
(2. 54±0. 15)
[12 ×]
3 4 5 6 7 8
1
2
3
4
5
[dB] 100 100
11 10
9
8
15507
6
9 10 11
3000 GND(PKG)
GND(PKG) IN/OUT
(R0. 3)
[12×]
Frequency[MHz] 12 GND(signal)
Fig. 2 Package dimensions(in mm) [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE JRC NSVA372
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JRC NSVA372 will begin.