User manual IBM THINKPAD 560X

[. . . ] i Note Before using this information and the product it supports, be sure to read the general information under "Notices" on page 231. First Edition (May 1996) The following paragraph does not apply to the United Kingdom or any country where such provisions are inconsistent with local law: INTERNATIONAL BUSINESS MACHINES CORPORATION PROVIDES THIS PUBLICATION "AS IS" WITHOUT ANY WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE LIMITED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Some states do not allow disclaimers or express or implied warranties in certain transactions; therefore, this statement may not apply to you. This publication could include technical inaccuracies or typographical errors. Changes are periodically made to the information herein; these changes will be incorporated in new editions of the publication. [. . . ] Follow the instructions on the screen to complete the installation. Default choices are already highlighted at the choice screens. 6 After the installation is complete, remove any diskette from the diskette drive and restart the computer. You have completed the installation of the PCMCIA device driver for Windows 3. 11. If you want to continue to install all device drivers, continue with "Installing the ESS AudioDrive Support Software for Windows 3. 11" on page 126. Chapter 7. Installing Software 125 Installing the ESS AudioDrive Support Software for Windows 3. 11 Installing the ESS AudioDrive Support Software for Windows 3. 11 Note: When installing an operating system, you need to install the ESS AudioDrive support software. 1 2 Turn on the computer and start Windows. from the pull-down menu. F ile O p t io n s W in d o w s E n te r F7 F8 Del A lt+ E n te r P ro g ra m M a n a g e r H e lp N e w. . . P ro p e rtie s . . . R u n . . . E x it W in d o w s . . . 3 4 5 Insert the AudioDrive Features Diskette for Windows into the diskette drive of your computer. Follow the instructions on the screen to complete the installation. You have completed the installation of the ESS AudioDrive support software. If you want to continue to install all device drivers, continue with "Installing the Infrared Device Driver for Windows 3. 11" on page 127. 126 IBM ThinkPad 560 User's Guide Installing the Infrared Device Driver for Windows 3. 11 Installing the Infrared Device Driver for Windows 3. 11 Note: When installing an operating system, you need to install the Infrared device driver. 1 2 3 Turn on the computer; then go to the DOS command prompt. Type A:UINSTALL and press Enter. The following screen appears: Installation Options Installation Source Drive Type the SOURCE drive letter (A-Z). When you install a program, the SOURCE drive letter is the location you are installing FROM. Source Drive . . . Enter F1=Help F3=Exit 4 Press Enter; then follow the instructions on the screen. Select Install Windows ThinkPad Infrared Driver when you are asked. You have completed the installation of the infrared device driver for Windows 3. 11. Chapter 7. Installing Software 127 Installing the ThinkPad Display Driver for Windows 3. 11 Installing the ThinkPad Display Driver for Windows 3. 11 If you did not install the display driver when Windows was installed (by following the procedures on page 120), you must install the ThinkPad display device driver. The display driver enables you to use various screen resolutions and colors for the LCD and external monitor. (See page 45 for possible combinations of resolution and color. ) The display driver also takes advantage of the computer's video capability. To install the ThinkPad device driver: 1 2 3 4 5 6 Turn on the computer. If Windows is running on your computer, exit Windows and switch to the DOS prompt. Select Display from the Windows Setup menu; then select Other (Requires disk. . . ). Insert the Video Features Diskette for Windows 3. 1 into the diskette drive; then type A:\ and press Enter. Follow the instructions on the screen. You have completed the installation of the display driver for Windows 3. 11. 128 IBM ThinkPad 560 User's Guide Installing Windows 95 Installing Software for Microsoft Windows 95 WIN This section describes the installation procedures for Windows 95 and its device drivers for your ThinkPad. Important If the device driver diskettes were not supplied with the computer, you need to create the diskettes using the Diskette Factory program (diskette backup program), which is preinstalled on your computer. The software shown in the following figure is already installed at the time of purchase. When reinstalling Windows 95, reinstall this software for your computer to work as it did at the time of purchase: Microsoft Windows 95 1 Page numbers: 1 Page 129. 6 Page 139. Install Windows 95 2 Install ThinkPad display driver 4 5 Install PC Card Director Install AudioDrive support software 3 Install ThinkPad Features program 6 Install Infrared support software 7 Start Computer Operation Installing Windows 95 Install Windows 95 as described in its documentation. Chapter 7. Installing Software 129 Installing the ThinkPad Display Driver for Windows 95 Installing the ThinkPad Display Driver for Windows 95 Note: To install the ThinkPad display driver for Windows 95, do the When installing an operating system, following: you need to install the ThinkPad display driver. [. . . ] During hibernation, the computer is automatically turned off to save power. When power is turned on again, the computer immediately restores the same data and applications as when hibernation started, without restarting the operating system. A graphic symbol, displayed on a screen, that a user can point to with a pointing device such as a TrackPoint III or mouse to select a particular function or software application. 236 IBM ThinkPad 560 User's Guide Glossary IDE. Often referred to as random-access memory (RAM), measured in kilobytes (KB) or megabytes (MB) of information. [. . . ]