User manual DYSON DC28

[. . . ] * Vuelva a iniciar el modo de alfombra seleccionando un tipo de piso diferente luego vuelva a seleccionar el botón para el tipo de piso deseado. ** Re-set the vacuum by turning it off for at least 30 seconds then on again. Stand the vacuum up straight and slide the hose into guides at the back of the vacuum and click into place. Attach the tools to the vacuum and wind the cord counter-clockwise around cord hooks and secure with clip. [. . . ] These are entirely harmless and are not associated with the mains supply. To minimize any effect from this, do not put you hand or insert any object into the clear binTM unless you have first emptied it and rinsed it out with cold water (see `Clear binTM cleaning' section). PLEASE NOTE: If you continue to experience problems, please contact the Dyson helpline for further assistance. The vacuum will always default to the `Med pile' setting when it is switched on and reclined. To change floor settings, press the button which best describes the floor type you are vacuuming whilst the vacuum is switched on. Clearing blockages is not covered by your vacuum's limited warranty. If any part of the vacuum becomes blocked, it may overheat and automatically cut-out. Switch `OFF' and unplug the vacuum and leave to cool down for at least 60 minutes before checking filters or for blockages. Check for obstructions along the length of the brush bar and around the end mountings. Always follow your floor covering manufacturer's recommended instructions. Clearing brush bar obstructions is not covered by your vacuum's limited warranty. Powerful suction can cause the hose to `pull back' ­ please take care. Take extra care when vacuuming on stairs; do not work with the vacuum above you on the stairs. To release the wand, open the wand cap and pull the red tube until the wand releases from the vacuum. The brush bar will not rotate when the vacuum is in an upright position. Switch `OFF' the vacuum and unplug before emptying the clear binTM. Empty as soon as the dirt reaches the level of the MAX mark ­ do not overfill. To replace cyclone unit onto the clear binTM, align grey button at reverse and push together. Check ridge at front of clear binTM has also clicked evenly into place. Do not immerse the whole cyclone in water or pour water into the cyclones. Do not use detergents, polishes or air fresheners to clean the clear binTM. ThANK yOu FOR ChOOSINg TO Buy A DySON vACuuM If you have a question about your Dyson vacuum, call the Dyson helpline at 1-886-693-9766 with your serial number and details of where and when you bought the vacuum. [. . . ] This limitation is not allowed by some States and so this limitation may not apply to you. Your remedy for breach of this warranty is limited to the warranty service described above. Will not be liable for any consequential damages or incidental damages you may incur in connection with your purchase and use of your vacuum. This limitation is not allowed by some States and so this limitation may not apply to you. [. . . ]