User manual DYSON BIG BALL

[. . . ] Do not disassemble the appliance as incorrect reassembly may result in an electric shock or fire. Do not close a door on the cable, or pull the cable around sharp edges or corners. Arrange the cable away from traffic areas and where it will not be stepped on or tripped over. Do not use to pick up flammable or combustible liquids, such as petrol, or use in areas where they or their vapours may be present. [. . . ] Do not use any lubricants, cleaning agents, polishes or air fresheners on any part of the appliance. If used in a garage, always wipe the base plate and ball with a dry cloth after vacuuming to clean off any sand, dirt, or pebbles that could damage delicate floors. Looking for blockages • • • • • • • • • • Switch ‘OFF’ and unplug before looking for blockages. Firmly twist the flexible inspection hose away from the inlet next to the ball (do not remove the end next to the connection for the main hose). VACUUMING • • Do not use without the clear bin and cyclone in place. This appliance is designed only for domestic use to remove household dirt, hair and allergens. The appliance is not designed to be used on: –– debris produced from activities such as DIY, building or similar tasks –– larger types and quantities of dust or debris, such as soot and sawdust. Fine dirt such as flour should only be vacuumed in very small amounts. Do not use the appliance to pick up sharp hard objects, small toys, pins, paper clips, etc. When vacuuming, certain carpets may generate small static charges in the clear bin or wand. These are harmless and are not associated with the mains electricity supply. To minimise any effect from this, do not put your hand or insert any object into the clear bin unless you have first emptied it and rinsed it out with cold water (see ‘Cleaning the clear bin’). Before vacuuming highly polished floors, such as wood or lino, first check that the underside of the floor tool and its brushes are free from foreign objects that could cause marking. Do not push hard with the floor tool when vacuuming, as this may cause damage. On waxed floors the movement of the cleaner head may create an uneven lustre. If this happens, wipe with a damp cloth, polish the area with wax, and wait for it to dry. To reduce suction (for example, when vacuuming rugs), pull the suction release trigger on the handle to reduce the airflow. Brush bar – clearing obstructions • • • • • • • If your brush bar is obstructed, it may shut ‘OFF’. Remove the brush bar by using a coin to loosen the fastener marked with a padlock until it clicks. Replace the brush bar and secure it by tightening the fastener until it clicks. Take care if coming into contact with them, as they may cause minor skin irritation. € • • • • • • • • • BRUSH BAR – TROUBLESHOOTING • If the brush bar has stopped spinning, follow the instructions above on clearing obstructions. [. . . ] den roterende børsten på støvsugeren kan skade enkelte teppetyper og ømfintlige gulvoverflater. Dersom du er usikker, trekk i utløseren for justering av sugestyrke for å redusere rotasjon av børsten. Hvis dette skjer, anbefaler vi å trekke i utløseren for justering av sugestyrke for å redusere rotasjonen av børsten. den roterende børsten på støvsugeren kan skade enkelte teppetyper og ømfintlige gulvoverflater. [. . . ]