User manual DUAL XD5120

[. . . ] XD5120 INSTALLATION/OWNER'SMANUAL AM/FM/CDReceiver XD5120INSTALLATION Preparation Please read entire manual before installation. · Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. GettingStarted · Remove 2 transit screws located on top of the unit. [. . . ] Activating this feature will enhance the bass frequencies when listening to music at all volumes. The radio frequency (tuner mode) or CD elapsed time/track (CD player mode) show by default. Volume Mute Display 6 XD5120OPERATION GeneralOperation SettheClock Press and hold DISP until the clock begins to flash, then release. Press EQto select between POP, CLASSIC, ROCK and OFF (default) equalization curves. The Bass and Treble settings are not adjustable when an EQ curve is selected. Press AUD to select between Volume (default), Bass, Treble, Balance & Fader. VOLUME BASS TREBLE BALANCE FADER PresetEQCurves Audio Bass Press AUD until BAS appears Press VOL- or + to adjust (-7 minimum / 7 maximum) Press AUD until TRE appears Press VOL- or + to adjust (-7 minimum / 7 maximum) Press AUDuntil BAL appears Press VOL-(LEFT)or + (RIGHT) to adjust (BA. L 10/BA. R 10) BAL 0 represents equal balance. Press AUD until FAD appears Press VOL- (FRONT)or +(REAR)to adjust (FA. F 10/FA. R 10) FAD 0 represents equal fader. Treble Balance Fader 7 XD5120OPERATION TunerOperation Tuning FMMono/Stereo Local/Distance Turn TUNE knob to select desired station. Press MONO during FM tuner operation to select mono or stereo (default) reception of the broadcast signal. Press LOC during FM tuner operation to activate local tuning for strong station reception only. Press BAND to select between FM and AM bands. Band 8 XD5120OPERATION CDPlayerOperation InsertCD EjectCD With the label facing up, insert a disc into the CD slot. If the disc is not removed within 10 seconds, the unit will reload the disc. Press Press to fast TrackSelect FastForward andReverse Pause Intro Repeat Random l l / II to temporarily stop CD playback. / II again to resume playback. Press INT to play the first 10 seconds of each track. Some CD-Rs and CD-RWs may be incompatible with this unit, depending on media type and recording method. CD-R/CD-RW Compatibility 9 XD5120WARRANTY LimitedOneYearWarranty This warranty gives you specific legal rights. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. agrees, at our option, during the warranty period, to repair any defect in material or workmanship or to furnish an equal new, renewed or comparable product (whichever is deemed necessary) in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase. Subsequent replacement products are warranted for the balance of the original warranty period. [. . . ] No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages. 10 XD5120OPERATION Specifications CDPlayer Frequency response: 20Hz-20kHz Channel separation @ 1kHz: >50dB D/A converter: 1Bit Tuning range: 87. 5MHz-107. 9MHz Usable sensitivity: 15dBf 50dB quieting sensitivity: 23dBf Stereo separation @ 1kHz: 25dB Frequency response: 80Hz-10kHz Tuning range: 530kHz-1720kHz AM sensitivity: 30uV Frequency response: 80Hz-1. 8kHz Operating voltage: 11-16VDC, negativeground Speaker output impedance: 4~8ohms Fuses: 0. 5ampfastblowAGC, 7ampfastblowAGC Dimensions: 7"x7"x2"(178x178x51mm) Design and specifications subject to change without notice. FMTuner AMTuner General CEA-2006 Power Standard Specifications (reference: 14. 4VDC +/- 0. 2V, 20Hz~20kHz) Power Output: 5 Watts RMS x 4 channels at 4 ohms and < 1% THD+N Signal to Noise Ratio: 65dBA (reference: 1 watt into 4 ohms) 11 XD5120OPERATION Troubleshooting Problem Unitwillnot turnon (nopower) Cause Yellow or red wire not connected or incorrect voltage Black wire not connected Action Check connections for proper voltage (11~16VDC) Check connection to ground Fuse blown Replace fuse Unithaspower Speaker wires not connected Check connections at speakers (butnosound) One or more speaker wires touching Insulate all bare speaker wires each other or touching chassis from each other and chassis ground ground Unitblows fuses Yellow or red wire touching chassis ground Speaker wires touching chassis ground Incorrect fuse rating Excessive skipping Unit is not mounted correctly or backstrap is not secure Physical defect in media (CD, CD-R or CD-RW) Errappearson Load/Eject operation error or disc is display in upside down Check for pinched wire Check for pinched wire Use fuse with correct rating Check mounting sleeve and backstrap support Check media for scratches Press eject Dual Electronics Corp. Toll Free: 1-866-382-5476 www. dualav. com ©2006 Dual Electronics Corp. [. . . ]