User manual DUAL XD5110

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual DUAL XD5110. We hope that this DUAL XD5110 user guide will be useful to you.


DUAL XD5110 : Download the complete user guide (424 Ko)

Manual abstract: user guide DUAL XD5110

Detailed instructions for use are in the User's Guide.

[. . . ] XD5110 INSTALLATION/OWNERS MANUAL AM/FM/CD Receiver XD5110 INSTALLATION Preparation Please read entire manual before installation. (consult a qualified technician for instructions) · Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. [. . . ] Press TRACK << to adjust the hours and TRACK >> to adjust the minutes. Press DISP momentarily to save the selected time. Bass Boost Volume Display Set the Clock 6 XD5110 OPERATION General Operation Reset Press and hold for more than 2 seconds to RESET the unit upon initial installation or if abnormal opeartion occurs. Press AUD to select between Volume (default), Bass, Treble, Balance & Fader. Audio Bass Press AUD until BAS appears Press VOLUME or to adjust (7 maximum / -7 minimum) Press AUD until TRE appears Press VOLUME or to adjust (7 maximum / -7 minimum) Press AUD until BAL appears Press VOLUME (LEFT) or (RIGHT) to adjust (BA. L 10/BA. R 10) BAL 0 represents equal balance. Press AUD until FAD appears Press VOLUME (FRONT) or (REAR) to adjust (FA. F 10/FA. R 10) FAD 0 represents equal fader. Treble Balance Fader 7 XD5110 OPERATION Tuner Operation Tuning FM Mono/Stereo Turn TUNE knob to select desired station. Press MONO during FM tuner operation to select mono or stereo (default) reception of the broadcast signal. Press BAND to select between FM and AM bands. Local/Distance Band 8 XD5110 OPERATION CD Player Operation Insert CD With the label facing up, insert a standard CD into the CD slot. If the disc is not removed within 10 seconds, the unit will reload the disc. Pressing TRACK << again skips to the beginning of the previous track. Press and hold TRACK << or TRACK >> to fast forward or reverse a track. Press Press Eject CD Track Select Fast Forward and Reverse Pause l l / II to temporarily stop CD playback. / II again to resume playback. Intro Press INT to play the first 10 seconds of each track. Some CD-Rs and CD-RWs may be incompatible with this unit, depending on media type and recording method. Repeat Random CD-R/CD-RW Compatibility 9 XD5110 WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. [. . . ] In no event shall the company be liable for indirect, incidental or consequential damages. 10 XD5110 OPERATION Specifications CD Player Signal-to-noise: >86dB Frequency response: 20Hz-20kHz Channel separation @ 1kHz: >65dB D/A converter: 1 Bit Tuning range: 87. 5MHz-107. 9MHz Usable sensitivity: 12dBf 50dB quieting sensitivity: 16dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz Tuning range: 530kHz-1720kHz AM sensitivity: 30uV Frequency response: 80Hz-2kHz Total power output: 100 Watts Peak Power output: 25Wx4 @ 4 ohms, 14. 4 VDC Operating voltage: 11-16 VDC, negative ground Speaker output impedance: 4~8 ohms Fuses: 1 amp fast blow AGC, 5 amp fast blow AGC Dimensions: 7" x 7" x 2" (178 x 178 x 51 mm) Design and specifications subject to change without notice FM Tuner AM Tuner General 11 XD5110 OPERATION Troubleshooting Problem Unit will not turn on (no power) Cause Yellow or red wire not connected or incorrect voltage Black wire not connected Action Check connections for proper voltage (11~16VDC) Check connection to ground Replace fuse Check connections at speakers Insulate all bare speaker wires from each other and chassis ground Check for pinched wire Check for pinched wire Use fuse with correct rating Check mounting sleeve and backstrap support Check media for scratches Press eject or RESET Fuse blown Unit has power Speaker wires not connected (but no sound) One or more speaker wires touching each other or touching chassis ground Unit blows fuses Yellow or red wire touching chassis ground Speaker wires touching chassis ground Incorrect fuse rating Excessive skipping Unit is not mounted correctly or backstrap is not secure Physical defect in media (CD, CD-R or CD-RW) Err appears on Load/Eject operation error display Namsung America Inc. South Kent, WA 98032 Toll Free: 1-866-626-7863 www. dualav. com ©2004 Namsung America, Inc. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE DUAL XD5110




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual DUAL XD5110 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.