User manual DUAL CS-455-1

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual DUAL CS-455-1. We hope that this DUAL CS-455-1 user guide will be useful to you.


DUAL CS-455-1 : Download the complete user guide (10720 Ko)

Manual abstract: user guide DUAL CS-455-1

Detailed instructions for use are in the User's Guide.

[. . . ] Automatic start - stop switch Preliminary operations Unpack the unit and all the accessories. [. . . ] 1) – Slide the cover 1 parallel to the position of the hinges 2 (opening angle approximately 60º) until it locks in position. Supply of the mains set (Australia only) The delivered mains set will be connected to the socket 10. The mains set, corresponding to the voltage Indicated on the nameplate has to be plugged in to the power-supply plug (230 V / 50Hz). Connection to phono stage, amplifier or receiver – Connect the audio cables 8 to the phono-magnetic inputs of the phonostage, amplifier or receiver (red RCA-type plug = right channel, white RCA-type plug = left channel). – Connect earth wire 9 to the earth connector of you amplifier. Automatic start, speed selection – The record diameter for the automatic start is also pre-selected when the record speed 33. 33 or 45 rpm 4 is selected. Therefore, only use the stylus types recommended in the techical date of the cartridge as replacement cartridges. Imitated styli result in audible quality losses and increased wear and tear of records. Pull of the stylus slanting downwards, Insert the stylus in the reverse mode (fig. 2) Technical data Measured values = typical values Model Belt drive Electronic-controlled DC motor DUAL CS 415-2 DUAL Mains voltage (mains set) 230V / 50 Hz oder Line frequency Power requirement Platter speeds Wow and flutter (DIN) Platter Tonearm Signal to noise ratio (DIN 45 500) Rumble unweighted signal to noise ratio Rumble weighted signal to noise ratio 50 Hz / 60 Hz 1. 5 W 33. 33, 45 U/min ± 0. 12 304 mm Ø Distortion-free aluminium tubular tonearm 40 dB 62 dB 211 mm 26º 19. 5 mm 0. 15º/cm Rad. [. . . ] DUAL DMS 251 S Effective tonearm length Offset angle Overhang Tangential tracking error Cartridge HiFi DIN 45 500 Red Green Blue White R RG LG L Right channel Right channel ground Left channel ground Left channel Diamond Stylus Conical DUAL DN 251S 15 µm O 20 mN 20 Hz - 18000 Hz 4 mV/5 cms-1/1kHz Tracking force Frequency range Output Compliance Horizontal Vertical 16 µm/mN 18 µm/mN 5g Cartridge weight Total capacitance Tonearm leads and audio cables ca. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE DUAL CS-455-1




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual DUAL CS-455-1 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.