User manual DEI ORION MAXXBASS

[. . . ] Please observe all local sound ordinances. WHY USE MAXXBASS® Orion will introduce the first MaxxBass® processor to the automotive market. The MaxxBass® processor is ideal for improving the perceived bass response in door mounted speakers without upgrading the speakers or amplifiers. MaxxBass® provides subwoofer like performance with perceived bass response to 30-40Hz on door mounted speakers. The MaxxBass® Processor is 2 recommended in two configurations. [. . . ] Choosing the appropriate location will depend upon your vehicle and the complexity of your system design. Typical mounting locations include the trunk and passenger compartment (floor or under seat). Never mount the MaxxBass® Processor in a location that would subject it to immersion or exposure to water. Once a location has been chosen, securely mount the MaxxBass® Processor with the four mounting screws. Inspect the area underneath to be sure you are not drilling into wires, brake or fuel lines, etc. that could be damaged by the drill bits or screws. 6 MAXXBASS® OUTLINE AND DIMENSIONS 5. i 51 n ( cm ) 14 I TEN SI N TY PO W ER CLI P O U TPU T I PU T N MI N 4. 6. M AX MI N M AX MI N M AX 80H z 60H z FR EQ U EN C Y ON O FF C R O SS O VER G N D R EM +12V R EM O U T 1. i 18 n ( cm ) 3 I PU T N O U TPU T PO W ER R EM O TE 7 WIRING CONFIGURATIONS The MaxxBass® Processor is recommended in two different configurations. Front Stereo Configuration The figure below illustrates the wiring for a front stereo configuration. One MaxxBass® Processor is used between the front channel source and front speaker amplifier to increase the bass response only on the front speakers. Implementing MaxxBass® on the front speakers will increase the perceived bass response of these speakers down to 30-40Hz providing a Virtual Subwoofer. The listener will achieve better bass balance and imaging with a rear mounted subwoofer or trunk mounted speakers with sufficient bass response. Front speakers with Virtual TM Subwoofer In-dash CD Receiver LF RF Front Rear Maxx Bass® LR RR Power Amplifiers Subwoofer 8 2. Dual Stereo Configurations For systems without rear subwoofers, the user may prefer to use two MaxxBass® Processors, one for the front speakers and one for the rear speakers. The units should be wired between the in-dash CD Receiver and the power amplifiers as shown below. In-dash CD Receiver Front speakers with Virtual TM Subwoofer LF RF Front Rear Maxx Bass® Maxx Bass® RF Rear speakers with Virtual Subwoofer TM RR Power Amplifiers NOTE: As an option, before beginning, disconnect the negative (-) terminal of the battery to prevent an electrical short to ground. Reconnect the negative terminal only after all connections have been made. WIRING PROCEDURES The next step is to connect the Power, Ground, and Remote IN/OUT wires to your MaxxBass® Processor. The power wire should run from the mounting location through the vehicle to the battery or power distribution block. firewall, etc. ), a grommet must be used to prevent the wire from chafing and shorting to ground. 9 The ground wire should be of the same gauge wire as the power wire. Find a location near the MaxxBass® Processor that is metal ( the floor is ideal) and clean an area about the size of a quarter to bare metal. Terminate the wire with a ring connector and attach it to the bare metal using a #8 sheet metal screw and washer (not supplied). After the connection is complete, coat the area with silicone or some similar material to prevent rust from developing. Finally, the remote IN wire needs to connect to the "Amplifier Remote" lead of the head unit. [. . . ] This warranty is non-transferable and does not apply to any unit that has been modified or used in a manner contrary to its intended purpose, and does not cover damage to the unit caused by installation or removal of the unit. This warranty is void if the product has been damaged by accident or unreasonable use, neglect, improper service or other causes not arising out of defects in materials or construction. ALL WARRANTIES INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY, IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, AND WARRANTY OF NONINFRINGEMENT OF INTELLECTUAL PROPERTY ARE EXPRESSLY EXCLUDED TO THE MAXIMUM EXTENT ALLOWED BY LAW, AND DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO ASSUME FOR IT ANY LIABILITY IN CONNECTION WITH THE SALE OF THE PRODUCT. DIRECTED HAS ABSOLUTELY NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES INCLUDING ITS AUTHORIZED DEALERS OR INSTALLERS. [. . . ]