User manual DEI FAILSAFE 103T Owners Guide

[. . . ] This warranty does not cover labor costs for the removal, diagnosis, troubleshooting or reinstallation of the unit. For service on an out-of-warranty product a flat rate fee by model is charged. Contact your authorized dealer to obtain the service charge for your unit. is not offering a guarantee or insuring against the theft of the automobile or its contents and disclaims any liability for the theft of the vehicle and/or its contents. [. . . ] The 103T can also be used as a serial controller for any of DEI's ESP systems. The ESP system LED can be plugged into the 103T's keypad port, so that the LED on the keypad functions as the main system LED. When connected to an ESP system, the 103T can be used to control such features as Panic, Valet Mode and emergency override. © 2000 Directed Electronics, Inc. 3 System Features Keypad Illumination Pressing any button will illuminate the keypad. The illumination will time out 5 seconds after the last key is pressed. PIN Code Security A personalized PIN code must be established to operate the various functions of the 103T. Enter the existing PIN code and the press 1234: s s s s s Press Press Press Press Press for 1. EXAMPLE: To enter the factory default PIN code of 4 © 2000 Directed Electronics, Inc. 4. 5. Within 5 seconds, enter the new PIN code followed The LED will flash twice. . Within 5 seconds, enter the new PIN code again followed by . The LED will light solidly for 1 second. The new PIN code has been programmed. The programming mode is exited if the ignition is turned off or if there is no activity for more than 5 seconds. If the PIN code programming mode is exited before a new PIN code is set, the unit will default to the existing PIN code. Operation as a Stand-Alone Starter Kill Arming When armed, the 103T will interrupt the starter wire when any attempt is made to start the vehicle. Passive arming occurs automatically 15 seconds after the ignition is turned off. The LED will flash steadily to indicate that the system is armed. © 2000 Directed Electronics, Inc. 5 Disarming The system may be disarmed whether the ignition is on or off. s s s Enter your personalized PIN code followed by pad is now disarmed. If the ignition is off, the unit will disarm, but the LED will flash rapidly to indicate that the system will rearm in 15 seconds. If the ignition is on, the system will disarm and the LED will turn off. If an error is made while entering the PIN code, simply press to start over. If the PIN code is entered incorrectly three times, the trigger sequence will begin. s If the ignition is turned on before entering the PIN code, the unit will honk the horn once (if connected). If the correct PIN code is not entered within 5 seconds, the trigger sequence will begin. Trigger Sequence (optional) . The key- When disarming, if the correct PIN code is not entered in three attempts or within 5 seconds after the ignition is turned on, the unit will honk the horn (if connected) for 30 seconds. If the ignition remains on, the unit will trigger again, up to four times. [. . . ] (labeled PANIC on the keypad). NOTE: When using the 103T as a stand-alone starter kill, the optional horn honk feature must be installed in order for Panic Mode to work. To activate or deactivate Valet Mode: When using 103T as stand-alone starter kill: 1. Press (labeled VALET on the keypad). The system has now entered Valet Mode. NOTE: If an incorrect sequence of buttons is pressed while attempting to exit Valet Mode, the system will ignore any new attempts to exit Valet Mode for 5 seconds. To arm: 1. NOTE: When using the 103T as a serial interface for a DEI ESP system, this feature may not currently be available. [. . . ]