User manual DEI AUTOMATE 410 Owners Guide

[. . . ] IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DEI OR ITS SUBSIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DEI SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DEI DEALER'S PURCHASE PRICE OF THE UNIT. DEI SHALL NOT BE RESPONSIBLE FOR ANY DAMAGES WHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANY CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES, DAMAGES FOR THE LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE. [. . . ] If the ignition is turned on while armed the horn will honk and the parking lights will flash (if connected). NOTE: You must use your remote transmitter to lock the vehicle in order for the system to be armed. Manually locking the vehicle does not arm the system; it will only lock the doors. If you have not used the remote transmitter to lock the vehicle doors (i. e. the vehicle has been locked using the lock/unlock switch) the transmitter cannot be used to unlock the doors. The system also can be programmed to arm the Failsafe® Starter Kill relay automatically (called passive mode). If the system is pro- 6 © 1999 Directed Electronics, Inc. grammed for passive mode, it will automatically activate the Failsafe® Starter Kill relay 30 seconds after the ignition is turned off. Passive mode is indicated by rapid flashing of the LED after the ignition is turned off. NOTE: For passive mode to be effective, the Failsafe® Starter Kill relay must be installed. If passive mode is programmed on, it is also possible to program the system to lock the doors automatically. If passive locking is turned on, care must be taken to prevent the keys from being locked in the vehicle. Disarming/Unlocking To disarm the security system and unlock the doors of the vehicle, press for one second. The Failsafe® Starter Kill will be deactivated and the vehicle's horn (if connected) will honk twice. The red status LED will go out, unless the system is programmed for passive mode. The LED will turn off when exiting Valet Mode. Panic Mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your transmitter!To stop Panic Mode at any time, press NOTE: In order for Panic Mode to function, the vehicle's horn (or optional siren) as well as the vehicle's parking lights must be connected. Rapid Resume Logic The system will store its current state to non-volatile memory. If power is lost and then reconnected the system will recall the stored state from memory. If the unit is in Valet® Mode and the battery is disconnected for any reason, such as servicing the car, when it is reconnected the unit will still be in Valet Mode. This applies to all states including arm, disarm, and Valet Mode. © 1999 Directed Electronics, Inc. 9 Programming Options Programming options control what your system does during normal operation, and require little or no additional parts. The following is a list of program settings, with the factory settings in Bold: s Passive mode or active mode. In passive mode the Failsafe Starter Kill relay will be automatically activated 30 seconds after the ignition key is turned off. s Both the ignition switch-controlled door lock and unlock features can be turned on or off. If ignition door lock is on, the vehicle's door will lock three seconds after the key is turned on. If ignition door unlock is on, the vehicle's doors will unlock when the key is turned off. s Passive door locking (with passive arming) or active door locking (only when arming with the transmitter). s s The locking and unlocking horn honk confirmations can be programmed on or off. [. . . ] The Failsafe® Starter Kill will prevent the vehicle's starter from cranking if it has been installed. The vehicle's horn (if connected) will honk and the parking lights will flash once to confirm arming of the system. ¢ Cut along dotted line where indicated for a quick and easy reference to keep in your purse or wallet. To disarm/unlock using your remote s To disarm the system and unlock the doors, press for one second. The Failsafe® Starter Kill will be deactivated and the vehicle's horn (if connected) will honk twice and the parking lights will flash twice. Disabling the Failsafe® Starter Kill without a transmitter s To do this, you must have the vehicle's ignition key and know where the Valet® switch is. Be sure to check with the installer for the location of the Valet® switch. [. . . ]