User manual D-LINK DI-804V

[. . . ] 020205 Building Networks for People Contents Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Basic Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Device Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Then, you can define the filtering policy by entering IP address range, the port range and select the protocol(s). For example, to prevent the remote user of IP address range (211. 21. 0. 1 to 211. 29. 0. 1) to access virtual WEB server (port 80), the setting are as follows, WAN Side Filter Enabled: Enabled Default WAN Side Filter: Pass Filter: Block Protocol: TCP IP Address Range: 211. 21. 0. 1 to 211. 29. 0. 1 Destination Port Range: 80 ~ 80 (HTTP) Modem String Settings 24 Modem string settings allow user to input detail settings for the analog modem. If you would like to change the baud rate settings, please check the initial string. (You can refer to the manual for your modem. ) Administration Settings PASSWORD SETTINGS You can give your VPN Gateway a new password. This password will be required the next time you configure your VPN Gateway. To enter a password, type your password in the new password field and type it again in the retype password field. If for any reason you lose or forget your password, press the small reset button located on the back of the device for 5 to 6 seconds. All configurations, including password, will be reset and require re-entering. 25 SYSTEM ADMINISTRATION Here, remote users can be set up to configure and administrate the VPN Internet Gateway through Internet. (IP address of 0. 0. 0. 0 means that any PC on the network can remote access and manage the VPN Internet Gateway). If you use this function, you have to enable the feature "Allow remote user to configure the device" first. Once you have enabled this function, type the VPN Internet Gateway WAN IP address (http://192. 168. 100. 1:1023) into the browser of any or specific PC 26 Note: Once HTTP port no (NOT PORT 80) is changed and the users of the LAN terminal want to configure the VPN Internet Gateway, the users have to type the VPN Internet Gateway LAN IP address with port number (http://192. 168. 0. 1:1023). System Parameters System Parameters allows user to setup the MTU value (Maximum Transmission Unit). For some areas, the ISPs set the limit packet size for PPPoE connection. User has to change MTU setting for surfing the net. 27 Save & Restart If you have finished making all the changes on the various pages, please click Save & Restart to save the settings and restart the device. If you would like to configure the setting again, you can browse those functions then click them. After the restart, the device will function according to the saved settings. Save & Restart lets you save the input settings to the VPN Internet Gateway (so as to be retrieved at a later time) and then restart it. 28 System Tools System Tools Detects the status of the VPN Internet Gateway. Intruder Detection Log The event messages show the possible hacker attacks that have occurred on your VPN Gateway. Up to 32 hacker attacks may be logged in this manner. Display Routing Table The Display Routing Table shows the current static routing configuration. 29 System Diagnostics System diagnostics shows your VPN Gateway's information. It will perform a check-up on your VPN Gateway to make sure that everything is functioning properly. 30 Save Settings This allows you to save the configuration to a file. If you would like to do this, click Save to save your current settings to a file. Then click save this file to disk in the browsing wizard. 31 Load Settings - Load Default Settings This allows you to load the original default settings of your VPN Internet Gateway. Load Settings - Load Settings From File This allows you to load the settings from a file. Upgrade Firmware 32 Upgrade Firmware The upgrade firmware option allows you to upgrade the latest firmware to your VPN Internet Gateway. Reset Device Resetting the device will restart it. Click on the START button to restart. 33 Configuring Your PCs to Connect to the DI-804V Router If you do not wish to set a static IP address on your PC, you will need to configure your PC to request an IP address from the gateway. In the configuration tab, select the TCP/IP protocol line that has been associated with your network card/adapter. [. . . ] Expedited shipping is available upon request and provided shipping charges are prepaid by the customer. · · · D-Link may reject or return any product that is not packaged and shipped in strict compliance with the foregoing requirements, or for which an RMA number is not visible from the outside of the package. The product owner agrees to pay D-Link's reasonable handling and return shipping charges for any product that is not packaged and shipped in accordance with the foregoing requirements, or that is determined by D-Link not to be defective or non-conforming. What Is Not Covered: The Limited Warranty provided herein by D-Link does not cover: Products that, in D-Link's judgment, have been subjected to abuse, accident, alteration, modification, tampering, negligence, misuse, faulty installation, lack of reasonable care, repair or service in any way that is not contemplated in the documentation for the product, or if the model or serial number has been altered, tampered with, defaced or removed; Initial installation, installation and removal of the product for repair, and shipping costs; Operational adjustments covered in the operating manual for the product, and normal maintenance; Damage that occurs in shipment, due to act of God, failures due to power surge, and cosmetic damage; Any hardware, software, firmware or other products or services provided by anyone other than D-Link; and Products that have been purchased from inventory clearance or liquidation sales or other sales in which D-Link, the sellers, or the liquidators expressly disclaim their warranty obligation pertaining to the product. While necessary maintenance or repairs on your Product can be performed by any company, we recommend that you use only an Authorized D-Link Service Office. [. . . ]