User manual D-LINK DGL-4100

[. . . ] Table of Contents Contents Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Minimum System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Features and Benefits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] It helps to reduce the impact that large low priority network packets can have on more urgent ones. If Dynamic Fragmentation is enabled, you can fine tune the fragment size. Select a smaller size if you have a slow uplink and VoIP quality is not optimal; select a larger size for faster uplinks. The speed at which data can be transferred from the router to your ISP. Alternatively you can test your uplink speed with a service such as www. dslreports. com. Automatic Classification: Advanced > GameFuel Dynamic Fragmentation: Max. IP Fragment Size: Uplink Speed: 25 D-Link Systems, Inc. Using the Configuration Interface Add/Edit GameFuel Rule Automatic classification should be adequate for most applications. GameFuel rules identify a specific message flow and assign priority to that flow. O receives the highest priority (most urgent) and 255 receives the lowest priority. The rule applies to a flow of messages whose LAN-side IP address is within the range set here. The rule applies to a flow of messages whose LAN-side port number is within the range set here. The rule applies to a flow of messages whose WAN-side IP address is within the range set here. The rule applies to a flow of messages whose WAN-side port number is within the range set here. When you are done editing the settings, you must click the Save Settings button at the top of the page to make the changes effective and permanent. TM Protocol: Source IP Range: Source Port Range: Destination IP Range: Destination Port Range: Save: GameFuel Rules List Entries on this list can be enabled/disabled by toggling the Enable checkbox. After you've completed all modifications or deletions, you must click the Save Settings button at the top of the page to save your changes. If you are finished with your configuration settings, click the Reboot the Device button. 26 D-Link Systems, Inc. Using the Configuration Interface Routing Add/Edit Route Adds a new route to the IP routing table or edits an existing route. Enable: Destination IP: Specifies whether the entry will be enabled or disabled. The IP address or network that the packets will be attempting to access Note: 192. 168. 1. 0 with a Netmask of 255. 255. 255. 0 means traffic will be routed to the entire 192. 168. 1. x network. Netmask: Used to specify which portion of the Destination IP signifies the network trying to be accessed and which part signifies the host that the packets will be routed to Note: 255. 255. 255. 255 is used to signify only the host that was entered in the Destination IP field. Gateway: Specifies the next hop to be taken if this route is used. A gateway of 0. 0. 0. 0 implies there is no next hop, and the IP address matched is directly connected to the router on the interface specified: LAN or WAN. Specifies the interface, LAN or WAN, that the IP packet must use to transit out of the router when this route is used. The amount of hops it will take to reach the Destination IP or network. A hop is considered to be traffic passing through a router from one network to another. If there is only one router between your network and the Destination network, then the Metric value would be 1. [. . . ] EXCEPT AS EXPRESSLY COVERED UNDER THE LIMITED WARRANTY PROVIDED HEREIN, THE ENTIRE RISK AS TO THE QUALITY, SELECTION AND PERFORMANCE OF THE PRODUCT IS WITH THE PURCHASER OF THE PRODUCT. Limitation of Liability: TO THE MAXIMUM EXTENT PERMITTED BY LAW, D-LINK IS NOT LIABLE UNDER ANY CONTRACT, NEGLIGENCE, STRICT LIABILITY OR OTHER LEGAL OR EQUITABLE THEORY FOR ANY LOSS OF USE OF THE PRODUCT, INCONVENIENCE OR DAMAGES OF ANY CHARACTER, WHETHER DIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL (INCLUDING, BUT NOT LIMITED TO, DAMAGES FOR LOSS OF GOODWILL, LOSS OF REVENUE OR PROFIT, WORK STOPPAGE, COMPUTER FAILURE OR MALFUNCTION, FAILURE OF OTHER EQUIPMENT OR COMPUTER PROGRAMS TO WHICH D-LINK'S PRODUCT IS CONNECTED WITH, LOSS OF INFORMATION OR DATA CONTAINED IN, STORED ON, OR INTEGRATED WITH ANY PRODUCT RETURNED TO D-LINK FOR WARRANTY SERVICE) RESULTING FROM THE USE OF THE PRODUCT, RELATING TO WARRANTY SERVICE, OR ARISING OUT OF ANY BREACH OF THIS LIMITED WARRANTY, EVEN IF D-LINK HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. THE SOLE REMEDY FOR A BREACH OF THE FOREGOING LIMITED WARRANTY IS REPAIR, REPLACEMENT OR REFUND OF THE DEFECTIVE OR NON-CONFORMING PRODUCT. THE MAXIMUM LIABILITY OF D-LINK UNDER THIS WARRANTY IS LIMITED TO THE PURCHASE PRICE OF THE PRODUCT COVERED BY THE WARRANTY. THE FOREGOING EXPRESS WRITTEN WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ANY OTHER WARRANTIES OR REMEDIES, EXPRESS, IMPLIED OR STATUTORY. [. . . ]