User manual CYBEX INTERNATIONAL 14051 LEG EXTENSION

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CYBEX INTERNATIONAL 14051 LEG EXTENSION. We hope that this CYBEX INTERNATIONAL 14051 LEG EXTENSION user guide will be useful to you.


CYBEX INTERNATIONAL 14051 LEG EXTENSION : Download the complete user guide (547 Ko)

Manual abstract: user guide CYBEX INTERNATIONAL 14051 LEG EXTENSION

Detailed instructions for use are in the User's Guide.

[. . . ] Cybex Total Access Leg Extension Owner's and Service Manual Strength Systems Part Number 14051-999-4 F www. cybexinternational. com Cybex Total Access Leg Extension Owner's and Service Manual Strength Systems Part Number 14051-999-4 F Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. VR3® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. 10 Trotter Drive Medway, MA 02053 · 508-533-4300 · FAX 508-533-5183 www. cybexinternational. com · techhelp@cybexintl. com · 14051-999-4 F Table of Contents Front Pages Table of Contents . [. . . ] Read and understand all instructions thoroughly before starting any of the procedures listed on this instruction sheet. WARNING: Use extreme caution when removing shipping cones and installing feet. With an assistant, carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench. Carefully place rubber feet (supplied with machine) on each foot of the frame. Using a 1/8" Allen wrench, remove the two Button Head Socket Cap Screws (BHSCS) securing the bottom bracket to the frame. NOTE: After final BHSCS is removed shroud will slide down to the floor with bottom support bracket attached. Carefully slide shroud out of machine. Assembly Page 4-1 Cybex Total Access 14051 Leg Extension Owner's Manual E. Slide spring loaded top guide rod cap down guide rod until guide rod cap is clear of frame. NOTE: Guide rod cap contains a compression spring that will fly if grasp is not released slowly. Carefully lean guide rods slightly outward, away from machine to clear pulley. NOTE: Excessive pressure on guide rods may damage lower guide rod caps. J. Carefully align weight plate over guide rods and slowly lower weight plate. NOTE: When installing weight plates, position plates so wide edges of bushing face upward and narrow edges of bushing face downward. Repeat step 5M-5N to install each weight plate. CO ECT RR WIDE bushing edge faces upward W NG RO NARROW bushing edge NOTE: The narrow bushing edge must face downward. Figure 1A O. Place springs and guide rod caps on guide rods (removed from step 5G). Compress guide rod caps and ailgn guide rod caps with weight frame holes and secure in place. NOTE: Guide rod caps must snap or lock into weight frame holes. Assembly Page 4-2 Cybex Total Access 14051 Leg Extension Owner's Manual 6. Verify belt is routed through top of pulley bracket and then route end of belt down to the top weight. Carefully lift top weight and verify that the position of the belt clamp (on the top weight) is aligned properly with the top pulley bracket. Without selecting any resistance, lift top weight up and down (simulating normal operation). Have an assistant verify that the belt is moving smoothly and is routed straight from the top pulley bracket to the top weight belt clamp. Weight Stack Correct belt routing Insert Belt Stem Wrong belt routing Insert Belt Stem Figure 2A Figure 2B Front Back Figure 3 Guide Rod 7. [. . . ] AVOID acid or chlorine based cleaners and also cleaners containing abrasives as these could scratch or damage the equipment. Maintenance Page 5-6 Cybex Total Access 14051 Leg Extension Owner's Manual 4. Guidelines for cleaning front panel: · · · · · · · Use clean soft cloths or sponges for application of cleaners and again for washing and rinsing. Don't apply cleaners in direct sunlight or at elevated temperatures. Compatible Cleaners and Detergents: · · · · · Formula 409 Top Job Joy Palmolive Windex with Ammonia D 6. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CYBEX INTERNATIONAL 14051 LEG EXTENSION




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CYBEX INTERNATIONAL 14051 LEG EXTENSION will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.