User manual CRESTON TPMC-12L
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CRESTON TPMC-12L. We hope that this CRESTON TPMC-12L user guide will be useful to you.
Manual abstract: user guide CRESTON TPMC-12L
Detailed instructions for use are in the User's Guide.
[. . . ] Crestron TPMC-12L IsysTM 12" Wall Mount Touchpanel Operations Guide
This document was prepared and written by the Technical Documentation department at:
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON
Regulatory Compliance
As of the date of manufacture, the TPMC-12L has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling.
Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment. [. . . ] If necessary, secure and label the attached cables before disconnecting them from the back of the touchpanel.
40 · IsysTM 12" Wall Mount Touchpanel: TPMC-12L
Operations Guide DOC. 6686B
Crestron TPMC-12L Hardware Hookup
Ventilation
IsysTM 12" Wall Mount Touchpanel
The TPMC-12L should be used in a well-ventilated area. If the TPMC-12L is hot to the touch, consider used forced air ventilation. To prevent overheating, do not operate this product in an area that exceeds the environmental temperature range listed in the table of specifications. Consideration must be given if installed in a closed or multi-unit rack assembly since the operating ambient temperature of the environment may be greater than the room ambient temperature. Contact with thermal insulating materials should be avoided on all sides of the unit.
Connect the Device
Make the necessary connections as called out in the illustration that follows this paragraph. Refer to "Network Wiring", "CAT5 Wiring" and "QuickMedia Wiring" on page 13 before applying power. If the TPMC-CH-IMC is to be used for connecting CAT5 audio and CAT5 video, refer to the latest revision of the TPMC-CH-IMC Operations Guide (Doc. 6345) for more information.
Hardware Connections for the TPMC-12L
Ground
MEMORY EXPANSION: For MMC Compatible Card
QM IN: QuickMedia Audio, Video & Mic Input Over CAT5
AUD I/O: Balanced Audio In & Mic Out Over CAT5
NET: To Control System and Other Cresnet Devices
USB: For 3rd Party Peripherals
LAN: 10/100/1000 Mbps High Speed Ethernet
VID IN: Balanced Video Input Over CAT5
CAUTION: Do not apply excessive pressure to the touchscreen display during handling. CAUTION: Use only the TPMC-CH-IMC Interface Module when connecting to the VID IN port. Use of the older "IMC" products, such as those with a 10-pin RJ-45 based interface, could damage the panel. NOTE: Ensure the unit is properly grounded by connecting the chassis ground lug to an earth ground (building steel).
Operations Guide DOC. 6686B
IsysTM 12" Wall Mount Touchpanel: TPMC-12L · 41
IsysTM 12" Wall Mount Touchpanel
Crestron TPMC-12L
NOTE: The TPMC-12L can only be powered by the 4-position terminal block connector labeled NET. Power cannot be supplied from network devices that are connected to the mini-terminal block connectors. NOTE: The Y and Z Cresnet data lines from the network are connected to the NET connector, which is internally wired to the 4-position mini-terminal block connector at each QM connector. (Does not necessarily apply to all QM products. ) NOTE: The maximum continuous current from equipment under any external load conditions shall not exceed a current limit that is suitable for the minimum wire gauge used in interconnecting cables. The ratings on the connecting unit's supply input should be considered to prevent overloading the wiring. NOTE: For optimum performance, Crestron strongly recommends using CresCAT-QM cable, available from Crestron. Other high-quality/low skew CAT5e/CAT6 wiring may also be used with varying performance. NOTE: For CAT5 and QuickMedia connections, use Crestron Certified Wire. NOTE: A QuickMedia transmitter such as the QM-TX is required in order to connect conventional video and audio sources to the QM IN port. NOTE: TPMC-12L touchpanels include a TPMC-CH-IMC Interface Module for system connection. [. . . ] MS, Microsoft Corporation, or their subsidiaries will not retrieve any personally identifiable information, or any other information, from your DEVICE by downloading such Security Updates. The SOFTWARE may contain NetMeeting, Remote Assistance, and Remote Desktop technologies that enable the SOFTWARE or other applications installed on the Device to be used remotely between two or more computing devices, even if the SOFTWARE or application is installed on only one Device. You may use NetMeeting, Remote Assistance, and Remote Desktop with all Microsoft products; provided, however, use of these technologies with certain Microsoft products may require an additional license. For both Microsoft products and non-Microsoft products, you should consult the license agreement accompanying the applicable product or contact the applicable licensor to determine whether use of NetMeeting, Remote Assistance, or Remote Desktop is permitted without an additional license. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CRESTON TPMC-12L
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CRESTON TPMC-12L will begin.