User manual BRANDT FP1364B

[. . . ] Do not put heavy weights on the oven door and make sure that children do not climb or sit on it. If a control panel for another appliance may be fitted to this appliance, only hobs recommended by the manufacturer must be used. After using the oven, make sure that all the controls are in the off position. Do not use steam or high pressure devices to clean the device (electrical device safety reasons) · The oven door should always be kept closed when working, for all programmes, including the grill. [. . . ] When roasting is complete, screw the spit handle back on and take it out of the oven. Choose the accessory or accessories to be used and their recommended position, or consult the cooking table. Turn the function selector and select the desired function according to the model (2. Several dishes may be cooked at once without their flavours or smells mixing. When you select the cooking function, the oven will recommend the optimum temperature and cooking will begin immediately. You can change this temperature within an upper and lower limit according to the programme selected. In all cases, when the cooking process is complete, turn the function selector dial to (2. After a few seconds the time will automatically be validated and the countdown will begin. 12 Selecting the end time : Select the cooking function, the temperature and the cooking time. The start of cooking will be delayed so that it finishes at the time shown. If you prefer the oven to function without a time limit, turn it to hand position . If you accidentally forget to switch off the oven, it will switch off automatically after a certain time has elapsed. The AquaSliding Function system makes it easier to clean the oven with steam. It takes 35 minutes and is done as follows: Spray 200 ml of water onto the inside walls of the oven. A) AquaSliding wait until the oven indicates the end of the cleaning cycle. After this time has elapsed, reduce the temperature to minimum (35ºC - 75ºC according to the model) and maintain for 25 minutes. Failure to follow these instructions may cause condensation on the front. At the end of the cycle, remove the water from inside and wipe away any remaining dirt with a dishcloth. This cycle is used to assist cleaning but loses its effectiveness if the recommended times are not followed. On these models, the rear plate and side panels are covered with a self-cleaning enamel that removes the grease while the oven is functioning. If the panels are not performing the selfcleaning process sufficiently, they will need regenerating. To do this, remove all the accessories and utensils from the inside of the oven. [. . . ] Depending on the models, the side runners are fixed in two ways, either without a support (3. When you have removed them, use a damp cloth to clean the side walls (3. If your oven has a fold-down grill, pull upwards and press to fold it down (3. Cleaning the outside of the glass: Use a soft cloth soaked in a glass cleaning product. [. . . ]