User manual BABYLISS ST30E

[. . . ] Thanks to the exclusive Wet N' Dry evaporation system, from now on you can use your straightener on damp hair. By using the dampness in your hair, you can straighten more deeply and thus obtain results that are even softer and silkier, and a hold that is even longer lasting. [. . . ] Progressively increase the temperature, if necessary, during the following uses. Use the table below as a guide: The LED of the selected temperature blinks until the temperature is reached, then it remains lighted during the whole using time. Hair type Fine, bleached and/or damaged hair Normal, coloured and/or wavy hair 130°C green LED 155°C yellow LED 155°C yellow LED 180°C orange LED 180°C orange LED 205°C red LED 230°C red LED Thick and/or very curly hair Take a section about 2 to 3 cm wide and place it between the two heating plates, near the roots of the hair. To avoid any risk of burn from the steam, make sure you do not point the straightener's steam vents at your face, scalp or hands. ⷠPress the straightener handles together, hold to keep the section between the plates and glide slowly from the roots to the tips. When you are straightening, you might hear some sizzling and see some steam. Do not be concerned, this could be because of evaporation of the sebum, some residual hair products (leave-in hair care, hairspray, etc. Take up a new section of hair and continue until your hair is all straight. ⷠRepeat again if necessary, then release the straightener. Hair can be spread evenly in the straightener and be untangled easily. If you do not want to use the comb, you can remove it by sliding it off the straighteners. ⷠIf your roots are still a little damp or if you would like to produce more volume, bend forward and gently dry with a hairdryer. Set your straightened hair with a light misting of hairspray or a little mousse, but certainly do not brush your hair. ⷠThe pro 230 Wet N' Dry straightener can also be used on dry hair. [. . . ] ⷠClean the plates using a soft, damp cloth, without detergent, to preserve the optimal quality of the plates. Store the straighteners with the plates pressed together to protect them. [. . . ]