User manual BABYLISS ST26E

[. . . ] Thanks to this technology, the plates are smoother and they guarantee perfect glide to respect your hair even more. On/off switch with indicator light · automatic shut-off · Swivel cord USE Before using, read the safety precautions at the end of the booklet. [. . . ] Use the table below as a guide : Temperature 130 ­ 160°C Hair type Fine, bleached and/or damaged hair Normal, coloured and/or wavy hair Thick and/or very curly hair Allow the hot straightener to heat up for about a minute. The red indicator light will stop flashing when the unit has heated up to the selected temperature. Your straightener is now ready to use; the red indicator light will stay on. ⷠTake a section about 2 to 3 cm wide and place it between the two heating plates, near the roots of the hair. Together, hold to keep the section between the plates and glide slowly from the roots to the tips. When you are straightening, you might hear some sizzling and see some steam. Do not be concerned, this could be because of evaporation of the sebum, some residual hair products (leave-in hair care, hairspray, etc. Take up a new section of hair and continue until your hair is all straight. ⷠRepeat again if necessary, then release the straightener. Set your straightened hair with a light misting of hairspray or a little mousse, but certainly do not brush your hair. To shape your hair The BaByliss pro 230 straightener may also be used to accent certain sections (fringe, tips turned in or out, etc. To lift the roots, take up a section and hold it straight out from the scalp, close the plates on the section and rotate the unit to the front to give the roots maximum volume. [. . . ] ⷠClean the plates using a soft, damp cloth, without detergent, to preserve the optimal quality of the plates. Store the straighteners with the plates pressed together to protect them. [. . . ]