User manual BABYLISS G897E WET & DRY O'LISS

[. . . ] ENGLISH O’LISS Used in the shower or in the bath, O’liss gives even the most sensitive skin an impeccable and comfortable epilation. The heat of the water in the bath or shower makes hair removal easier, turning epilation into a moment of true relaxation.  xclusive patented system with 2 epilation heads that rotate in opposite E directions and at irregular intervals – double efficiency even on the shortest of hairs (0, 5 mm). [. . . ] Epilation - In the bath: For maximum comfort, start your epilation a few minutes after relaxing in the warm bath water. The heat will cause your skin’s pores to dilate making hair removal easier. Your leg should be damp but not completely submerged in the bath water. - n the shower: For good depilation in the shower, make sure your skin is I thoroughly wet. - On dry skin: You can also use the appliance out of the bath or shower, but be careful to remove all traces of oil or moisturiser from your skin. Turn the appliance on by pressing the button once for speed I or twice for speed II. Hold the appliance at an angle of 90 degrees to the surface of where hair is to be removed. Always work with both hands: carefully stretch the skin with one hand while moving the appliance with the other. Only move your epilator against the direction of the growth of your hair. Careful not to press S the appliance down too hard against your skin; it might slow down and be less effective. Epilation of sensitive areas: we recommend putting the accessory for sensitive areas on the head of your epilator. It reduces the number of hair remover disks so that you can remove hair more smoothly and with greater precision. IMPORTANT • Only use BaByliss O’liss for hair removal and following the instructions in this manual. € Do not remove hair from areas with open wounds, cuts, burns, warts, moles, sunburnt skin or varicose veins. [. . . ] Du skal blot sørge for, at huden forinden er helt fri for spor eller olie eller fugtighedscreme. Tænd for apparatet ved at trykke én gang på knappen for hastighed I eller to gange for hastighed II. Slå på apparatet ved å trykke én gang på knappen for hastighet I eller to ganger for hastighet II. [. . . ]