User manual BABYLISS 8480E

[. . . ] the set includes also 4 professional accessories (scissors , nail clippers , toe-nail clippers and cuticle pusher). Instructions for Use Charging The BaByliss Professional Nail Care System should be charged using only the charger supplied. ensure that the switch on the handle is in the "off " position , marked "0". [. . . ] ⷠAreas of unwanted rough or hard skin may be reduced using the detail file (1). The side of the detail file may be used to carefully remove areas of hard skin beside the nail wall (c). ⷠIn some cases, where ridges and furrows are present on the nail plate, it may be desirable on occasion to use the buffing disc (4) to gently and carefully reduce the unevenness. Polishing Place a small amount of polishing cream on the nail plate, avoiding the cuticle. Select and fit smoothing disc (4) and polish on speed I for a maximum of 15 seconds per nail. ⷠSeparate the toes, either using a roll of cotton wool plaited between the toes, or with sponge separators. ⷠIf necessary use the large nail clippers to cut your nails. shaping · Using the filing disc on speed II shape the toe nail. The most desirable shape for toe nails (d) is for them to be filed straight across. ⷠIf necessary, reduce to speed I to finish off the shape, and to smooth the edge. ⷠCalluses and any other areas of unwanted rough or hard skin may be reduced using the callus remover. Start with a test on speed I before a more efficient treatment on speed II. ⷠIn some cases, where ridges and furrows are present on the nail plate, it may be desirable on occasion to use the buffing disc to reduce the unevenness. Polishing Proceed as for fingers (see "Polishing" section) Important: always use the BaByliss Professional Nail Care System on the lower speed setting first and then move to the higher setting if needed. ⷠAfter the application of varnish, place the appliance (with fan attachment) at about 20cm distance from your fingers. Charging the Appliance Before using the Appliance for the first time, charge continuously for 16 hours. [. . . ] ⷠDo not use the Nail Care System if you have any lesions or wounds. ⷠStop using the appliance immediately if the cord is damaged. The cord must be replaced by the manufacturer, its after-sales service or a similarly qualified person to prevent any risk to the user. [. . . ]