User manual BABYLISS 5721E

[. . . ] The sloped combs easily penetrate the hair and go as close to the roots as possible. M et al -C er a m ic g r i d , gives an extreme shine to the hair while respecting it. 2 speeds and 3 temperatures may be combined in order to adapt perfectly to every hair type. [. . . ] To remove the attachment Press the 2 buttons on either side of the appliance while gently loosening the attachment ( B ). E x p e rt's advice Always start combing wet hair at the ends then slowly work your way up towards the roots. Select the tension recommended for your hair type using the Tensio Control System located on the side of the straightener attachment. (C) E x p e r t's advice -The first time you use the attachment, set it at tension 1 (weakest tension) to familiarise yourself with the Be Liss. -Gradually increase the tension until you find the best setting for your hair. E x p e r t's advice -Whatever type of hair you have, start the pre-drying by bending at the waist, allowing your hair to fall forward to better lift the roots and give your style volume. -If, however, you prefer less volume, stand with your head straight to pre-dry your hair. POSITION OF THE ROTATING HEAD To carry out the above 3 steps effectively, regardless of the section to straighten, the straightener attachment rotates (4 possible positions). To change the position, press the 2 buttons on either side of the appliance ( B ), turn the attachment, and then release the buttons rotating the nozzle until it 'clicks' into place. E x p e rt's advice Ideally, the teeth of untangling comb should be positioned facing down and used on the hair first: comb through and then straighten the hair. Clip the upper layer of hair on top of your head to begin with the hair underneath and at the nape of the neck. - To reduce the volume of thick or voluminous hair, place the Be Liss on top of the section of hair ( F). - If your hair is quite fine or lifeless, place the Be Liss underneath the section of hair ( E ), it will straighten while lifting the roots giving the effect of volume. Place the Be Liss (untangling comb facing down) at the roots ensuring that the teeth of the untangling comb penetrate the hair fully ( D ). With a slight twisting motion of the wrist, turn the appliance under and slide it slowly down the length of your hair: the action of the moving Metal/Ceramic straightening combs is thus maximised. Place the Be Liss (untangling teeth facing down) under the section of hair ( D ). With a slight twisting motion of the wrist, turn the appliance under and slide it slowly towards the ends, using your free hand if necessary to turn the hair up ( E ). With a slight twisting motion of the wrist, turn the appliance over and slide it slowly towards the ends, using your free hand if necessary to turn the hair up ( F). [. . . ] Always ensure that the voltage of the power source used matches that indicated on the hairdryer. The cord must be replaced by the manufacturer, its after-sales service or a similarly qualified person to avoid harm to the user. Return the hairdryer to the repair centre nearest you for inspection, adjustments, or electrical or mechanical repairs. [. . . ]