User manual ATLANTIC ULYSSE

[. . . ] Installing a machine at altitude causes an increase in air output temperature (of the order of 10°C per 1000m above sea level). Remove and retain the two screw covers - Fit the whole assembly using the screws provided. - Place the towel holder up against the lower parts of the wall bracket. [. . . ] In damp premiPilot wire=Black ses, such as bathrooms and kitchens, install the connecting box Three possible cases at least 25cm from the ground. - The installation must comply The pilot wire end is insulated 1st case: only one heater and not further connected with local national regulation. If To the appliance with cassette or in doubt, ask the national 2nd case: Slave heater programming unit. - If power cable is damaged or too short, to avoid any danger it must be replaced by a qualified electrician using special tools. Bathroom), the pilot wire supply must be protected on this differential. Chart indicating the orders the device can receive over its pilot wire B) Set wheel B, the heating indicator C lights up if the ambient temperature is lower than the temperature desired. D) If the setting suits you (use a thermometer to check, if need be), mark the position once and for all. 3) Anti-Frost mode This mode enables you to maintain the temperature in the room at around 7°C during prolonged absences from home (generally more than 24 hours). to restart , remove the item blocking one of the device's grills and set the switch A to Stop. - This device is not intended for use by persons (including children) with physical, sensory or mental disability, or by persons lacking experience or knowledge, unless they have received from a person in charge of their safety adequate supervision or preliminary instructions on how to use the device. - Please ensure that children do not lean on the device or play close to it when it is operating : its surface may be hot enough to cause burns to their skin in some circumstances, particularly because their reflexes may not yet have been acquired or are slower than those of an adult. - Take care not to allow any foreign bodies or paper to enter the device. - Any work inside the device must be done by a qualified professional tradesman. - When conducting any work on the device, it is essential that it be set to the STOP position and have cooled down before being unhooked from its bracket. - To maintain the device's performance, the upper and lower grills must be cleaned with a vacuum cleaner or a brush approximately twice a year. - Every five years, have the internal components checked by a qualified electrician (cleaning and interfacing). [. . . ] - In dirty environments, stains may appear on the device's grill. such stains do not justify replacement of the device under guarantee. (To be presented by the user only in the event of a claim) - The guarantee period is two years from the date of installation or purchase and may not exceed 30 months from the date of manufacture in the absence of a receipt. [. . . ]