User manual AOPEN NX6B-HW
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AOPEN NX6B-HW. We hope that this AOPEN NX6B-HW user guide will be useful to you.
Manual abstract: user guide AOPEN NX6B-HW
Detailed instructions for use are in the User's Guide.
[. . . ] Chapter
2
Hardware Installation
Electrostatic discharge (ESD) can damage your processor, disk drives, expansion boards, and other components. Always observe the following precautions before you install a system component. [. . . ] For using this function, you just need to press <Home> key first and then press Power button at the same time. Note that do not release <Home> key until POST sreen appearing.
"
!
!"# = 44$; '/
1
;
' :
/
The specification of AGP is maximum 66Mhz clock. If the bus clock is larger than 66MHz, setting this item to Enabled may cause serious system damage.
!"
# $
-
, "!/
!"#
% "
# $$$
-
/
#
$
#
8
'
Attach fan cable to either CPU FAN connector or FAN connector. Both of these two fans connectors can support hardware monitoring function, however, you can only use the CPU FAN connector to control the fan power ON/OFF.
&#
#%&
4$
'
'
%
' $
#%&'
4$
'
'
"(
#)&*
A
'
(
'
&
'
.
&6
'
'
&
% +
, /
,
. $
/
B
>!B
'
-$$
2!$ 3 2!$< 2
2!$
(45 -$$'
3
$
$
<
/01+
=2!$ 2
2!$
/
2!$
This motherboard does not support EDO DRAM. "2
/ ($=4> 35$+</ &$=4> 3(4$+</ >$=4> 38&$+</ 5$=4> 34>$+</ (4$=4> 3(&5$+</
/ ($=4>=& 3(4$+</ &$=4>=& 38&$+</>$=4>=&34>$+</5$=4>=&3(&5$+< Here is a trick to check if your DIMM is single-side or double-side -- if there are traces connected to golden finger pin 114 and pin 129 of the DIMM, the DIMM is probably double-side; otherwise, it is single-side. Following figure is for your reference.
768MB memory is achieved by using 64M bit Registered SDRAMs.
. -C'
(&/
'
(& = ' 2!$ 58$:;
2!$'
47/
='47$:;
Some SDRAMs marked as -10 may work fine with 100 MHz CPU clock, but not all this kind of modules can work properly under 100MHz external clock. We suggest you choose and install SDRAMs that match ( '' specification if 100MHz or above CPU clock is selected.
-$$
-$$
/
+
/
-$$
-$$ '
! -$$
'
/
'
. (&'()$+-(&'()#"5+$&#!&'>'
C)4+/
>' 2!$
To identify 2-clock and 4-clock SDRAM, you may check if there are traces connected to golden finger pin 79 and pin 163 of the SDRAM. If there are traces, the SDRAM is probably 4-clock; Otherewise, it is 2clock. # '% +-
-$$ #/
-$$ #
'
/ +- #
-$$#
0
;
-
+-/
;
'$&6'%, "27"2'38"2'38"2'3
2!$-$$
! [. . . ] When next time, if memory is read with odd number of "1", the parity error is occurred and this is called single bit error detection.
!
C@)
/
# - / -!/ -1
/
/
0
C)2$
9%'+:
9$():
/
" [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE AOPEN NX6B-HW
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AOPEN NX6B-HW will begin.