User manual AMICA OTC6541BG

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AMICA OTC6541BG. We hope that this AMICA OTC6541BG user guide will be useful to you.


AMICA OTC6541BG : Download the complete user guide (1881 Ko)

Manual abstract: user guide AMICA OTC6541BG

Detailed instructions for use are in the User's Guide.

[. . . ] L The textile grease filter should be replaced, and the aluminium filter should be cleaned at least every one month in connection with the existing fire danger (saturated fat is very lflIaf manmyaobthlee)r. Safe operation is possible when during simultaneous operation of the hood and combustion devices dependent on air supply the negative pressure of not more than 0. 004 milibar is maintained at the location of these devices inside the room (this point does not apply when the hood is used as an odour ab- The power wire gets Broken, it should be re- Placed with a new one in Make sure the ap- Pliance can be easily The plug out of the mains Unless they have been Use of the appliance by They do not play with the The local power supply Kept away from children The mains power sup- Ply always check that Ed to make sure the Beneath the hood itself With regards to the Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazardsii Setting the air extractor mode of operation of the hood In the extractor mode air is discharged to the outside by a special conduit. The hood should be connected to the opening discharging air to the outside by means of a rigid or flexible conduit of 120 mm diameter, which should be purchased in a shop selling installation materials. [. . . ] To start the hood, extend the telescopic element and start the hood motor at speed 1, 2 or 3 and/or switch on the light (left side of the appliance). OTC 614 BG - Figure 4c The hood is operated by means of a set of sensors located in the front part of the retractable telescopic panel. To start the hood, extend the telescopic element and start the hood motor at speed 1, 2. To use the timer function, touch the Timer sensor while the hood is running (the display shows flashing digit , , 0"), then use sensors + or - to select the desired switch-off time delay. After setting the switch-off time, touch the Timer sensor again to confirm and start time count. Correct setting will be indicated by a flashing dot on the display at the hood speed setting. Motor and start delay function work only when the telescopic panel is extended. OTC6541WG / OTC6541BG - Figure 4e The hood is operated by means of a set of sensors located in the front part of the retractable telescopic panel. Timer You can set the timer to turn off the appliance after up to 15 minutes. To set the timer touch Speed 1, 2 or 3 while the appliance in operation. Touch Speed 1, 2 or 3 again to cancel timer and turn off the appliance . Maintenance Regular maintenance and cleaning of the device will ensure faultless operation, and help extend the life of the unit. Attention should be paid to replacing grease and carbon filters according to instructions. Aluminium grease filter Cleaning For normal hood operation, aluminium grease filter should be cleaned every month in the dishwasher or by hand using a mild detergent or liquid soap. to replace: Dismantling of aluminium grease filter is shown on Figure 5. This filter should be replaced at least once every two months or more frequently if the appliance is used intensively. Use incandescent / halogen / LED modules of the same specification as those factory-installed in the appliance. L Do not use solvents or alcohol, as they may tarnish lacquered surfaces. L Do not use caustic substances, especially for cleaning stainless steel. Operation - Carbon filters can be used only when the hood is not connected to any ventilation duct. [. . . ] Increase the fan speed: Speed 1: 1 Speed 2: 2 Speed 3: 3 Timer You can set the timer to turn off the appliance after up to 15 minutes. To set the timer touch Speed 1, 2 or 3 while the appliance in operation. Touch Speed 1, 2 or 3 again to cancel timer and turn off the appliance . Pericolele care iau natere de pe urma manipulrii incorecte a echipamentelor cât i a activitilor care pot fi realizate numai de ctre o persoan calificat, cum ar fi de ex. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AMICA OTC6541BG




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AMICA OTC6541BG will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.