User manual AKG SRA 1

[. . . ] this Manual contains important information on setting up and operating the equipment. Please take a few minutes to read the instructions below carefully before operating the equipment. [. . . ] The antenna has a hypercardioid polar pattern that points 5° to 20° up, depending on the antenna's distance from the floor, wall, or ceiling. the polar pattern is identical in transmitting and receiving modes and increases the "reach" of the antenna. The main lobe of the hypercardioid pattern is located in front of the front disk. If it does not, set the Frequency Range Selector on the antenna to its alternative position. Use the supplied SA 40 stand adapter to mount the antenna on a microphone stand making sure that the connector points straight down. ) from any walls or other plane surfaces, metal grids, or metal scaffolding as shown in fig. , for diversity reception), check that the two antennas are spaced at least 20 cm (8 in. If the ceiling is high enough you can cover the entire performance area by mounting a single antenna on the ceiling and pointing it down. Aim the antenna like a spotlight at the center of the performance area (stage). Therefore, aim the antenna 5° to 20° lower than the direct line of sight to the performance area (see fig. You may also use the SRA 1 directional antenna in small rooms or on small stages where the antenna will be less than 10 m (33 ft. In receiving mode, the antenna will receive signal even from spots within the performance 2. [. . . ] Connect the other end of the antenna cable to the antenna input of your receiver or Power Splitter. You can connect the antenna to the following UHF equipment: SR 300 and SR 81 receivers, PS 81 Power Splitter. [. . . ]