User manual AKG HUB 4000 Q

[. . . ] And do not expose it to direct sunlight, excessive dust, moisture, rain, mechanical vibrations, or shock. To avoid hum or interference, route all audio lines, particularly those connected to the microphone inputs, away from power lines of any type. If you use cable ducts, be sure to use separate ducts for the audio lines. Be sure to disconnect the power supply from the power outlet before cleaning the equipment! [. . . ] 1 in-line power supply (as checked on the packaging) Should anything be missing, please contact your AKG dealer. System ArchitectTM control software from Harman Pro, available as a free download from www. The status LED next to the ON/OFF key will be lit green to indicate power is on. HiQnet LINK: This green LED will be lit constantly to indicate the unit is connected to a HiQnetTM network. HiQnet DATA: This green LED will flash to indicate the unit is receiving or sending data. DATA TRANSFER TO AKG DEVICE 1-8: These blue LEDs indicate the status of data exchange between the HUB 4000 Q and the AKG devices connected to it. Each LED is assigned to one of the rear panel AKG NETWORK DEVICES 1 through 8 data ports. Each LED indicates the following conditions: LED flashing: Data is being exchanged between the assigned data port on the HUB 4000 Q and the connected AKG device. Once every 3 seconds): There is a communication problem between the assigned data port on the HUB 4000 Q and the connected AKG device (hard or software error, defective data cable, etc. Operate the equipment with the included power supply with an output voltage of 12 VDC, 500 mA only. Using adapters with an AC output and/or a different output voltage may cause serious damage to the unit. Prior to setting up the unit, check that the AC mains voltage stated on the included power supply is identical to the AC mains voltage available where you will use your system. Using the power supply with a different AC voltage may cause damage to the unit. â· Although the equipment will operate on both 10-Mbit and 100-Mbit networks, we recommend using a 100-Mbit network. ) A single HUB 4000 Q allows you to control up to eight AKG devices from a computer. You can use one or more commercial switches (Ethernet hubs, routers, etc. ) to daisy-chain several HUB 4000 Qs and control the entire setup from the computer. Plug a straight-through network cable into the HiQnet LINK socket of each HUB 4000 Q. [. . . ] This is absolutely necessary because this type of software may interfere with data communications within the HiQnetTM network. This means that System ArchitectTM will automatically assign an unambiguous TCP/IP address to the network card and to each AKG device on your network. Never use caustic or scouring cleaners or cleaning agents containing alcohol or solvents since these may damage the enamel or plastic parts. â· Switch unit OFF, wait for 10 seconds, switch unit back ON. [. . . ]