User manual AKG CK93

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC regulations. Changes or modifications not expressly approved in writing by AKG Acoustics may void the user's authority to operate this equipment. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ] Screw a short bracket (6) to the outer side panel of each transmitter using for each bracket two of the screws (2) you removed from the transmitter side panels. Insert the two supplied batteries (2) into the battery compartment, aligning the batteries with the polarity symbols inside the battery compartment. If you insert the batteries the wrong way, the receiver will not be powered. Alternatively to the supplied dry batteries, you may use the optional BP 4000 battery pack from AKG. The BP 4000 fits into the battery compartment in the correct orientation only, so you cannot insert it the wrong way. Please note that standard rechargeable batteries may damage the receiver if the charging contacts are shorted and will provide no meaningful remaining-battery-life indication. AKG will accept no liability for any damage resulting from the use of standard rechargeable batteries. - Status LED is lit red: power to receiver is off or batteries will be dead in less than 60 minutes. - Status LED remains dark: no batteries or dead batteries inside battery compartment. When powering up for the first time, the first thing you need to do is select a Preset. When powering up again later, the receiver will automatically come on in LOCK mode. 11): You can feed the same stereo monitor signal to one or more SST 4500 transmitters. Connect the stereo monitor outputs on your mixer to the two AUDIO IN jacks on the rear panel of the first transmitter. Connect the AUDIO LOOP jacks on the first transmitter to the AUDIO IN jacks on the next transmitter. 12): You can use one channel to distribute the same mono monitor mix to several SST 4s while feeding a personalized monitor signal for each musician to the other input channel on each SST 4500. This allows each musician to set their own balance between the two signals on the receiver. Explain to the musicians how to set the balance between the band mix and their own signals on the receiver. The "FREE" tag incidactes how many clean frequencies have been found. If this number is zero, you can raise the squelch threshold and try again. Remember, though, that a higher squelch threshold reduces the system range. ⷠClean frequencies are frequencies where the receiver finds no RF signal or an RF signal whose level is lower than the set threshold. Tune the transmitter assigned to the first receiver to the same frequency that you selected on the receiver and switch power to the transmitter on. [. . . ] In SETUP mode, turn the jog switch CW or CCW a s many times as required to display "ATT. In SETUP mode, turn the jog switch CW or CCW a s many times as required to display "ATT. The hearing protection limiter places an absolute ceiling on the receiver output level. Please note that the actual sound pressure at the ears will depend on the type of earbuds used. [. . . ]