User manual AKG CK 33

[. . . ] With integrated DPA-P XLR phantom power adapter, programmable ON/OFF switch, switchable bass cut, defeatable LED ring, and PS 3 F-Lock panel mount socket. 2765Z0017): The GN 15 HT Installation Module allows you to connect any Discreet Acoustics Capsule Module to the HT 4000 handheld transmitter from AKG. ) gooseneck with mini jack plug, HCS mounting flange, and permanently connected DPA phantom power adapter with 3-pin XLR connector. ) cable, and DPA phantom power adapter, an ST 305 floor stand, and a 10-cm (4-in. [. . . ] You can double-check on that through the opening for the ON/OFF key as you push the circuit board home. Use the supplied PS 3 F-Lock panel mount socket to install the Installation Module in a tabletop or an optional SA 60 stand adapter to mount the Installation Module on a floor or table stand. â· For even better vibrational noise rejection, you can fix the Installation Module to the tabletop with an optional H 500 (see fig. Use a shielded cable to connect the Installation Module to a microphone input with phantom power. If the phantom power on your mixing console is switchable, switch the phantom power on. 1 LED Ring The LED rings on the GN 15/30/50 E operate off phantom power. If you connected the microphone correctly, the LED will be lit at moderate intensity as soon as you switch the system and phantom power on. This indicates that the system is correctly wired and ready to operate but NOT that the microphone channel is open. 4: DPA circuit board The DPA phantom power adapter provides a 6-dB/octave bass cut filter below 200 Hz to reduce low-frequency noise. Before grasping the circuit board, touch a bare, grounded metal part to discharge any static charge that may have built up on your body. Pins 2 and 4 on the 5-pin XLR connector are available for powering the LED ring from an external source. The LED rings on the GN 15/30/50 Installation Modules will be powered from the phantom supply. ) To obtain an open channel indication, the installation technician may connect the LED ring to an external power source. In this mode, the LED ring will light much more brightly to draw the required attention to the open microphone. Unsolder the black wire (LED +) and the outer shield (LED -) from the DPA phantom power adapter. Thread the connecting cable of the Installation Module through the opening and the supplied fixing screw. Screw the fixing screw into the Installation Module from below to fix the Installation Module in place. â· For even better vibrational noise rejection, you can fix the Installation Module to the tabletop with an optional H 600 + A 608 shock mount (see figs. [. . . ] Fix the fishing line to two opposite walls so as to create just enough downward pull to steady the microphone laterally. Screw the desired Capsule Module onto the GN 15 HT Installation Module CW. Screw the Installation Module onto the HT 4000 handheld transmitter CW. Use the SA 63 stand adapter supplied with the transmitter to mount the transmitter on an (optional) ST 45 table stand. [. . . ]