User manual AKG CGN 523 E

[. . . ] To dispose of the packaging, make sure to use a collection/recycling system provided for that purpose and observe local legislation relating to waste disposal and recycling. The Discreet Acoustics Compact Series comprises four gooseneck microphones, one flown microphone, and dedicated accessories for every application and every type of venue. ) cardioid gooseneck microphone with integrated DPA XLR phantom power adapter and external foam windscreen. [. . . ] the microphones have been designed for connection to microphone inputs with 9 to 52 V phantom power. To connect Discreet Acoustics Compact microphones to inputs without phantom power, refer to Section 4. Use the optional PS 3 F-Lock panel mount socket to install the microphone in a tabletop or an optional SA 60 stand adapter to mount the microphone on a floor or table stand. For even better vibrational noise rejection, you can fix the microphone to the tabletop with an optional H 500 or H 600 shock mount. Use a shielded cable to connect the microphone to a microphone input with phantom power. If the phantom power on your mixing console is switchable, switch the phantom power on. ) The microphone is powered directly from the phantom power source on the console. Prior to installing the microphone, straighten the cable by carefully pulling it through your fingers. Fasten a hook to the ceiling, use an existing hook, or stretch a fishing line across the hall. Pass the cable through the hook or over the line so that it will hang at the desired height. This may cause the cable to twist and misalign the microphone after a while. Hold the cable with one hand and turn the microphone carefully into the desired position. If you use spotlights, be sure to turn them on before aligning the microphone. When you turn the spotlights off, the microphone will rotate out of alignment. Upon turning the spotlights back on, the microphone should rotate back into its original position. Leave an appropriate length of fishing line through the eyelet on the spring clamp of the CHM 21. [. . . ] The DPA phantom power adapter is equipped with a bass cut filter to minimize low-frequency noise. Unscrew the fixing screw on the microphone or DPA phantom power adapter. Pull the circuit board out of the case WITH CAUTION ­ so as not to break the internal leads. [. . . ]