User manual AKG C747 V11

[. . . ] This Manual contains important instructions for setting up and operating your equipment. Please take a few minutes to read the instructions below, particularly section 1 Safety and Environment, carefully before operating the equipment. Please make sure that the piece of equipment your microphone will be connected to fulfills the safety regulations in force in your country and is fitted with a ground lead. [. . . ] AKG phantom power supplies allow you to connect the microphone to unbalanced inputs as well. Use an XLR cable to connect the microphone to a balanced XLR input with phantom power. (Refer to the instruction manual of the unit to which you connected your C 747 V11. ) · If your mixer provides no phantom power, connect an optional AKG B 18 phantom power supply between the microphone and the mixer. You may connect the AKG B 18 phantom power supply to an unbalanced input as well. 1 Mounting All supplied mounting accessories have 3/8" inside and/or outside threads, so you can screw the H 47 mic clamp as well as the MSH 70 gooseneck on to any standard floor or table stand. ⷠTo fix any of the supplied mounting accessories to a 5/8" thread, use a commercial 3/8" to 5/8" thread adapter. Use the SA 80 to clamp the microphone on a desktop, microphone stand, flats, or other parts of a stage set up to 0. Due to its reduced size and slight presence rise the C 747 V11 is an excellent choice for speech miking in conference and discussion situations as well as radio, TV and recording studios. 7: Alternatively, you can clamp the microphone to the desktop using the SA 80. You can use the SA 47 stand adapter to mount the microphone on a table stand. The saxophone radiates all of its frequencies within the 3-dB band from the bell. If you want less key click noise, move the microphone further away from the instrument and/or aim it al the outer rim of the bell. The strings, wood, lacquer, and playing style all affect the tone and it's these delicate influences that you should try to capture. [. . . ] ⷠPlace the C 747 V11 where you would place a conventional spot microphone. SPL for 1% THD: Equivalent noise level to IEC 60268-4: Equivalent noise level to IEC 60268-4 (A-weighted): Signal/noise level re 1 Pa (A-weighted): Impedance: Recommended load impedance: Powering: Current consumption: Connector: Size: Net weight: condenser (self-polarized) hypercardioid 30 Hz to 18 kHz ±3 dB from published trace 8. To order a free copy of the Declaration of Conformity, visit http://www. [. . . ]