User manual AEG-ELECTROLUX 165H107RB

[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. â· Never allow children or people unfamiliar with the instructions to use the lawnmower. â· Never mow while people, especially children, or pets are nearby. â· Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. [. . . ] For proper bag function and appearance, it may be necessary to adjust the bagger assembly. There should be 6mm (1/4")-9mm (3/8") gap between the bagger top and fender and the bagger top surface should be even with the top surface of the fender. Loosen only enough so the brackets keep their position, but allow them to be moved. Move the brackets the amount forward or backward you wish the bag assembly to move. Loosen only enough so the brackets keep their position, but allow them to be moved. Move the brackets the amount up or down you wish the bag assembly to move. Make sure that the letter "A" on both the plug and handle are on the same side and that they can both be seen from the top when laying on the ground. The throttle control regulates the engine revs and thus the rotation speed of the blades. = Full speed = Idling speed When the pedal is pushed down the brake is applied and the motor is disengaged. There are four different positions for this lever: N = Neutral (no drive) S = Slow F = Fast R = Reverse The lever can be moved steplessly between S and F to ensure the required speed. Move the lever forward to connect the drive to the cutting unit, whereby the drive belt is tensioned and the blades begin to rotate. If the lever is moved backwards the drive will be disconnected and the rotation of the blades slowed down by the action of the brake shoes on the pulley. Quick lifting/lowering of the cutting unit Pull the lever backwards to quickly lift the cutting unit when passing over irregularities in the lawn, etc. During transportation the cutting unit shall be in the highest position. There are three different positions for the ignition key: OFF All electric current broken. Never leave the key in the ignition lock when leaving the machine on its own. To release the parking brake all that is necessary is to push down the brake pedal. To tow or move the tractor without the aid of the engine, the free-wheel control knob must be pulled out and locked in position. When the engine is cold the choke should be pulled out before starting. When the engine has started and is running smoothly push the choke in. Do not smoke when filling with petrol or fill up when the engine is warm. The combined oil refilling cap and the oil stick is accessible when the bonnet is lifted forwards. [. . . ] When the correct distance (A) is obtained this setting is locked with the nut (1). At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance "A" should be the same or within 6mm (1/4") of each other. â· If adjustment is necessary, make adjustment on one side of mower only. [. . . ]